SCM series super thin mill is on the bases of our company’s production experience for more than 15 years. We absorb advantags from the same trade abroad and at home. We review, research and try on 12 kinds of mills and horizontal hammer crushers. And finally we developed this high-efficiency and low-cost super thin mill by investigation and trial.

This grinding mill is a equipment which produces thin powder and super thin powder. It is applicable to non-flammable and non-explosive materials with hardness less than 6, such as calcite, chalk, limestone, dolomite, kaolin, bentonite, talcum, talc, magnesite, illite, pyrophyllite, vermiculite, sepiolite, attapulgite, rectorite, diatomite, barite, gypsum, alum earth, graphite, fluorite, variscite, potash ore, floatstone.




This grinding mill is mainly composed of host machine, redactor, separator, fan, cloth dust controller, piping device, integrated device, and electric engine etc. The whole set of equipment is composed of jaw crusher, belt bucket-elevator, feeder machine, storage silo, electrical control tank etc. It is mainly applicable for grinding of mineral materials used in metallurgy, construction , chemical engineering, mining etc and various non-inflammable and non-explosive mineral materials with Mohs’ scale of hardness less than grade 9 and moisture 6%.

Performance features:
1. It can be applied in a wider range than airflow miller.

2. Compared with other micronizers, the rolling pressure upon materials form grinding roller with the help of high-pressure spring has increased 800-1200 kg.

3. Energy saving. In the case of the same output and fineness, its energy consumption is only one third of that of airflow miller.

4. Smaller investment and more benefit. In the case of the same output and fineness, the price is only one eighth of that of airflow miller.

5. It can be fed with large particles. The average diameter of discharged particles after being milled for once is below <6.5um.

6. The grinding setting adopts superposed multilevel sealing. So it has good sealing.

7. The dust cleaning meets the state dust discharging standard.

Repair and maintenance:
1. Lubricate the centre bearing of the host machine every 4 shifts and the bearing of blower every month.

2. The temperature of bearing chamber shall be no more than 70℃.

3. When changes the roller sleeve, it is necessary to clean the bearing of the roller and bearing chamber.

4. Proper play is required when assembling bearings. (No informing, if there is any change of technical data.)

SCM series S super thin mill Detail Specification: